• About us
  • Our principles
  • Team and contact person
  • Company history
  • Museum

• Services, References
  • Metal panels on buildings
  • • Metal panel facades/gables
    • Metal balconies/garages
  • Plumbing
    • Metal roof, Metal roofing, Metal roofs
    • Metal facade
    • Fiber cement cladding
    • Roof drainage
    • Dormer cladding
    • Chimney cladding
    • Renovation of historical buildings
  • Sanitary and housing technology
  • Sheet metal forming
  • Interior work made from metal
  • Services sector

• Service Center
  • Current info/press reports
  • Downloads

• Contact
  • Address
  • Contact sheet
  • Map

• Zur deutschen Website

Technical information for panel facades

Substructure made of wood

The centre-distance from bolt to post is aligned according to the load of own-weight and wind-burden and can only be a maximum of 0.6 m. Also a seating of at least 40 mm in the mounting area of the panel is needed. A substructure of wood is only useful for small areas.

Substructure made of metal

Screws or pins on one side of the profile attach the panels onto the substructure. For a length over

1.80 m they are fixed directly – in the middle when mounted horizontally and in the upper part of the panel when mounted vertically. By using two pieces or more for substructures, building tolerances can be equalized. In addition, only a few places with temperature exchange will be created.

Material and colours

Available material:	Thickness
Titan zinc pre-weathered	1.0 mm – 0.8 mm
Copper	0.7 mm – 1.0 mm
Colour-coated aluminium	0.7 mm – 1.2 mm
Steel plate, colour-coated	0.6 mm – 0.9 mm
Perforated steel plate, titan zinc, copper, aluminium	0.7 mm – 1.0 mm

RAL-Colours:

An overview of the advantages: Non-baring, real-ventilated, under airing facade system No full substructure needed Individual design in colour and material For new buildings and renovations Fast mounting due to prefabricated elements For inside and outside